Dish Alignment Quick Start:
Assemble your dish.
Install your LNBF on your dish and tilt the LNBF to compensate for polarization skew for the satellite your dish is pointing at, and for your location.
Mount your dish on its mast. Make sure mast is 100% vertical and solid.
Calculate your Azimuth and Elevation.
Turn your dish towards the correct Azimuth and hand-tighten screws.
Adjust dish Elevation to correct value and hand tighten screws.
Connect your receiver to the LNBF using RG6 coaxial cable. Make sure the receiver is unplugged before you connect the LNB.
Turn your receiver "ON".
Receiver Quick Start:
Press "Menu".
Press right volume arrow to go to "Installation".
Click "OK".
Select "Antenna Setting" and use the following settings:
- Antenna: 1
- LNB Type: UNIVERSAL (For Fortec Star LNBF - Low: 9750, High: 10600)
Note: If you are using a "Standard" LNBF, then select:
LNB Type: “SINGLE”, then Click "OK".
Enter the LNB value, i.e., Single: 10750.
Press down arrow to "STORE", then click "OK".
- LNB Power: V/H
- 22Khz: Off
- DiSEqC: Off
- 12V: Off
Press down arrow to "STORE", then click "OK".
Press down arrow to "Channel Search", then click "OK".
- Search Index: 1
- Antenna: 1
- Satellite: Select "Telstar_5 (97.0W)"
- Search Mode: NIT FTA
- Click "OK" on TP Data
- Use the right buttons on the remote to select transponder frequency 11898, or 12177.
- Click "OK".
- Positioner: OFF
Now adjust your dish alignment if you do not see the "Signal" and "Quality" bars turn GREEN in color. Once the bars turn green move down to the "START" button.
Click "OK" to search channels
Congratulations, you just downloaded the channels to your receiver!